Administration and Provisioning
8-80 Issue 8.0 July 2002
NOTE:
While cross-connections are deleted, the FT-2000 OC-48 Add/Drop-Rings
Terminal will report several trouble conditions (for example, circuit
provisioning error and path integrity failure). However,
these trouble conditions should be ignored until all the cross-connections
for a circuit have been deleted. If the trouble conditions remain after all the
cross-connections have been deleted, refer to the "Operation and
Maintenance (TOP)" section (Volume II).
For more information about deleting cross-connections at an FT-2000 OC-48
Add/Drop-Rings Terminal, refer to the Operation Task Index in the "Operation and
Maintenance (TOP)" section (Volume II).
†If the specified slot is part of a slot pair (for example, slot 1A and 1B) that has been
provisioned for the OC-3 1+1 protected mode, specifying one slot also includes the
companion slot. The same type of logic applies to OC-12 1+1 protected mode.
To Next Page
Loading...
Need help?
General