Administration and Provisioning
Issue 8.0 July 2002
8-105
* Available in Release 4.1 and later releases.
† Select the desired port by installing the appropriate cabling.
‡ The baud rate is determined by the clock to the X.25 interface.
§ Available in Release 3 only.
¶ Available in Release 4 and later releases.
** Prior to Release 4.1, there is a maximum of 12 logins per system. In Release 4.1 and later releases, there is a
maximum of 100 logins per system.
†† At startup, there are exactly two privileged logins and no others.
‡‡ FT-2000 is the original value of the password for ATT01 and ATT02. There is no original password value for
any other logins.
§§ The FAULT-Retrieve-State reportmayalsobeused.
¶¶ In Release 4.1 and later releases, the low speed port state can be provisioned separately in the add and drop
directions.
*** Available in Release 5 and later releases.
††† In Release 4 and 4.1, the timeout parameter was provisioned using the FT-2000 CIT-PC setup menu.
‡‡‡ CIT provisionable in Release 4.1 only.
§§§ CIT provisionable in releases prior to Release 6 only. Auto provisioned in Release 6 and later releases.
¶¶¶ Available in Release 6 and later releases.
**** Available in Release 7.1.0 and later releases.
Path Information
-XmitPathTrace¶ ≤
64 characters
(Releases 4 and
5)
CIT
CONFIGURATION-
Set-Path-Trace
[ENT-STS1]
CONFIGURATION-
Retrieve-Path-
Trace
[RTRV-PTHTRC]
-RcvPathTrace¶ ≤
62 characters (Release 6 and
later)
[No original value]
Table 8-5. Provisionable Parameters (FT-2000 OC-48 Add/Drop-Rings Terminal) (Contd)
Parameter Options [Original Value] Method
CIT-PC Input
[TL1 Command]
CIT-PC Report
[TL1 Report]
To Next Page
Loading...