Administration and Provisioning
Issue 8.0 July 2002
8-131
■ At least 2 of the characters must be nonalphabetic
■ At least 1 of the characters must be symbolic (The \, @, #, ?,
$, or space not allowed) (the comma, :, ;, or _ not allowed)
■ The difference between upper and lower case is significant.
If ENTER is pressed, the system will default to the current
password.
— The Re-enter Password parameter confirms the New Password
parameter. Reenter the exact characters that were entered for the
New Password parameter.
— The User Privilege parameter sets the user's security level for
nonprivileged users to one of the following:
— "Reports Only": User will be able to execute only the
Retrieve
, Set-Password, Operate-Alarm Cutoff, and
Test-LED inputs
— "General": User will be able to execute all commands, except
Initialize-System
, Set-Far End Communications,
Set-Login, Set-Network Element, and Set-Security.
The user privilege parameter for a privileged user can only be set to
Privileged.
— The Visitor parameter specifies whether the login will be changed to
a visitor login (Yes or No). A visitor login is a temporary login.
— The Status parameter enables or disables the login. The status
parameter for a privileged user can only be set to Enabled.
■ SECURITY-Set-Login-Delete (TL1 = DLT-USER-SECU): This input
deletes a nonprivileged login. If the login is active at the time this command
is executed, the user is immediately logged off the system.
— The Login parameter selects the login that is to be deleted. (The
Retrieve-Login input will list login IDs.)
To Next Page
Loading...