Administration and Provisioning
8-132 Issue 8.0 July 2002
■ SECURITY-Set-Login-Enter (TL1 = ENT-USER-SECU): This input
enters a new login, including password and user privileges. A privileged
user can create up to 98 nonprivileged logins. There are 2 privileged user
IDs allowed per network element.
— The New Login parameter is the login ID for the login being created.
It must be a string of from 1 to 10 alphanumeric characters, in which
the difference between upper and lower case is significant, and it
must be different from all other login IDs in this network element.
— The New Password parameter is the password for the login being
created. A password consists of a string of alphabetic, numeric, or
symbolic characters conforming to the following rules:
— String must contain from 6 to 10 characters
— At least 2 of the characters must be nonalphabetic
— At least 1 of the characters must be symbolic (the \, @, #, ?,
$, or space not allowed)
— The difference between upper and lower case is significant.
— The Re-enter Password parameter confirms the New Password
parameter. Reenter the exact characters that were entered for the
New Password parameter.
— The User Privilege parameter sets the user's security level to one of
the following:
— "Reports Only": User will be able to execute only the
Retrieve
, Set-Password, Operate-Alarm Cutoff, and
Test-LED inputs
— "General": User will be able to execute all commands, except
Initialize-System
, Set-Far End Communications,
Set-Login, Set-Network Element, and Set-Security.
— The Visitor parameter specifies if the new login will be a visitor login
(Yes or No). A visitor login is a temporary login.
To Next Page
Loading...