Craft Interface Terminal Usage
Issue 8.0 July 2002
11-57
The fields of the report are described below:
Destination/
Source
- Shows the target identifier and may be either the
destination node or the source node. Blank spaces are
shown when a tributary is not cross-connected.
NID - Shows the legal node identifier value (1 through 16) that
originated/terminated from the west. A dash is shown when
the tributary is not cross-connected. A question mark is
shown when a tributary is cross-connected to an incorrect
Source/Destination TID. An asterisk is shown for invalid
TID/NID pairs.
DRI - Shows the dual ring interworking (dri) cross-connection as
A (active cross-connection) or S (standby
cross-connection).
Cross-Connection - Shows the line, direction, and tributary number where the
STS3 signal is added/dropped/through connected in this
network element. Active dri cross-connection is shown by
dashes (--) whereas the standby dri cross-connection is
shown by periods (..).
DRI - Shows the dual ring interworking (dri) cross-connection as
A (active cross-connection) or S (standby
cross-connection).
NID - Shows the legal node identifier value (1 through 16) that
originated/terminated from the east. A dash is shown when
the tributary is not cross-connected. A question mark is
shown when a tributary is cross-connected to an incorrect
Source/Destination TID. An asterisk is shown for invalid
TID/NID pairs.
Source/
Destination
- Shows the target identifier and may be either the source
node or the destination node. Blank spaces are shown
when a tributary is not cross-connected.
To Next Page
Loading...