Craft Interface Terminal Usage
11-60 Issue 8.0 July 2002
The previous report shows information on the add/drop/through configuration of
an FT-2000 Add/Drop Rings Terminal. If no cross-connections are found, the
heading of this report will print, followed by the message:
The output parameters are:
Source AID - The STS-1 Tributary or Port Address identifier
Destination
AID
- The STS-1 Tributary or Port Address identifier.
Type - The type of connection.
Source TID - The signal entry source destination (LOCA).
Destination
TID
- The signal exit destination (LOCZ).
Primary State - The status of 1WAYDRI and 1+1 protected OC-3 interface
cross-connections. The values are ACT (active) or STBY
(standby).
Invalid Flag - An asterisk displays (first character of the Source/Destination
TID) if a provisioned cross-connection does not exist in the ring.
AUDIT
Parameter Flag
- A "+" displays (last character of the Type field) if a provisioned
cross-connection has its AUDIT parameter set to "No." If the
AUDIT parameter is set to "Yes," the last character is blank.
To Next Page
Loading...