Craft Interface Terminal Usage
11-82 Issue 8.0 July 2002
Release 2 (Use the SECURITY category.)
The above report for an FT-2000 end terminal shows the provisioned parameters
and values from the SECURITY-Set-Network Element command. Also
shown are the results of the site address (SADD) autoprovisioning.
An FT-2000 repeater bay/shelf report is the same except it does not have the
Site 0 parameter. An FT-2000 repeater bay/shelf site is automatically provisioned
with a site address for each OC-48 line.
TID - Shows the unique identification of an FT-2000 network element.
Site 0 - Shows if an FT-2000 end terminal has been provisioned to be
Site 0, either Yes or No.
Site
Address
- Shows the confirmed F-byte address (site address) of the
FT-2000 network element from the auto provisioning function. If
questions marks (??) appear as part of the value, then auto
provisioning has not been completed or it failed.
TERMB 92-01-19 23:15:15 EST
M Retrieve-Network Element: COMPLD
/* FT-2000 System Provisioning Report
=============================================================
Parameter Value
=============================================================
TID TERMB
Site 0 No
Site Address site-1-04
site-p-04
*/
;
To Next Page
Loading...