Lucent Technologies FT-2000 OC-48 - Page 835

Craft Interface Terminal Usage
Issue 8.0 July 2002
11-127
Releases 4, 5, and 6 (Use the PERFORMANCE category.)
The report shows the current performance-monitoring threshold crossing alert
(TCA) values for the DS3 line and path. This report is not available at the repeater
site.
The fields of the report are described below:
Address - Shows the specific DS3 low-speed slot and port.
Bin - Shows the quarter-hour (QH) and the day bins.
TCA Report - Shows if the automatic reporting of TCAs is enabled or
disabled.
DS3 Line
ES-L
- Shows the provisioned number of line errored seconds for
the QH and day bins that will cause a TCA.
BER - Shows the provisioned bit error rate for the QH and day bins
that will cause a TCA.
CV-P - Shows the provisioned number of code violations for the QH
and day bins that will cause a TCA.
ES-P - Shows the provisioned number of errored seconds for the QH
and day bins that will cause a TCA.
SES-P - Shows the provisioned number of severely errored seconds
for the QH and day bins that will cause a TCA.
SAS-P - Shows the provisioned number of severely errored frame/AIS
seconds for the QH and day bins that will cause a TCA.
UAS-P - Shows the provisioned number of unavailable seconds for
the QH and day bins that will cause a TCA.
/* DS-3 Performance Monitoring Threshold Value Report
==========================================================================
TCA DS3 Line --------------- DS3 Path -------------
Address Bin Report ES-L BER CV-P ES-P SES-P SAS-P UAS-P
==========================================================================
ls-1a-1 QH Enable 5 -9 500 25 10 50 5
Day Enable 3 -9 500 250 10 50 3
ls-1a-2 QH Enable 5 -9 500 25 10 50 5
Day Disable 3 -9 500 250 10 50 3
ls-1a-3 QH Disable 5 -9 500 25 10 50 5
Day Disable 3 -9 500 250 10 50 3
*/
;