Lucent Technologies FT-2000 OC-48 - Page 850

Craft Interface Terminal Usage
11-142 Issue 8.0 July 2002
The following example shows how a manual switch condition is displayed at the
node where the manual switch is initiated.
The following example shows what is displayed at the node located at the
opposite end of the line being switched.
The following example shows what is displayed at the remaining node(s) on the
ring network.
A dash ("-") indicates that information is not available for that entry (for example,
the slot is not equipped).
-----------------------------------------------------
trmtr-1e TRMTR active manual-ring
trmtr-1w TRMTR standby manual-ne
-----------------------------------------------------
rcvr-1e RCVR active manual-ring
rcvr-1w RCVR standby manual-ne
-----------------------------------------------------
trmtr-1e TRMTR standby manual-fe
trmtr-1w TRMTR active manual-ring
-----------------------------------------------------
rcvr-1e RCVR standby manual-fe
rcvr-1w RCVR active manual-ring
Lucent Technologies-FT-2000 96-07-19 23:15:15 EST
M Retrieve-State:All: COMPLD
/* State Report
=======================================================================
Address Circuit Port Switch Switch
Pack State State Priority
=======================================================================
ls-1-1a DS3 aaa active -
ls-1-1b DS3 iii active -
.. . . .
.. . . .
.. . . .
ls-p-8b - - - -
ls-p-p1 DS3 standby
ls-p-p2 - - -
Press F3 to return to input mode.
*/
;