Craft Interface Terminal Usage
Issue 8.0 July 2002
11-169
Additional Training on an FT-2000
Add/Drop-Rings Terminal 11
45.
NOTE:
You are now going to use CONFIGURATION-Set-State-T3 to set the
administrative state of port 1 of slot 1A to NMON for a DS3 circuit pack. If an
STS1E or OC-3 circuit pack is in slot 1A, then select another slot that
contains a DS3 circuit pack (use this new slot reference throughout the
procedure). (After completing this portion of the tutorial, you may want to
set the port state to AUTO.)
Depress function key to return to the input mode and select
CONFIGURATION-Set-State-T3 by using the F3, ←, →, ↑, and ↓
arrow keys to highlight the command and press .
F3
ENTER
To Next Page
Loading...
Need help?
General