Lucent Technologies FT-2000 OC-48 - Page 935

365-575-102 Operation and Maintenance: IXL-001
Issue 8.0, July 2002 Page 11 of 14
FT-2000 MULTIPLEXER
TAP-107 Address Environmental Input Condition
TAP-108 Address Missing or Incorrect Response
TAP-109 Address ‘Incoming (From OC-48) DS3 AIS’
TAP-110 Address Incoming Signal Failure
TAP-111 Clear ‘Circuit Pack Failure’
TAP-112 Clear ‘Circuit Pack Removed’
TAP-113 Clear ‘SYSMEM Failure’ or ‘SYSCTL Failure’
TAP-114 Clear Trouble When ‘ABN’ LED Is Lighted
TAP-115 Clear Automatic Switch Condition
TAP-116 Clear Unsuccessful Circuit Pack Replacement
TAP-117 Clear ‘Excessive Holdover’
TAP-118 Clear ‘Fan Failure’
TAP-119 Clear ‘Fuse/Power Failure’
TAP-120 Clear ‘Incoming DCC Failure’ or ‘Inc. (From OC48) DCC Failure’
TAP-121 Address ‘Line FERF’ or ‘Incoming OC-48 Line RFI/Yellow’
TAP-122 Address ‘Path AIS’, ‘Path Yellow’, ‘Incoming (from OC-48) DS3 LOF’,
‘Inc(from STSX) Line RFI/Yellow’, ‘Inc(from OC48) Path RFI/Yellow’,
‘Incoming OC3 Line RFI/Yellow’, and ‘Incoming OC12 Line RFI/Yellow’
TAP-123 Clear ‘CP (Unknown Type) Failure’
TAP-124 Address ‘Reset in Progress’
TAP-125 Clear ‘SYSMEM Unrecognizable Code’
TAP-126 Clear ‘SYSMEM/SYSCTL Code Mismatch’
TAP-127 Clear ‘Unexpected CP Type’
TAP-128 Clear Trouble in CIT (CIT Does Not Respond to Commands)
TAP-129 Clear ‘DCC Startup in Progress’
TAP-130 Clear ‘Site Provisioning Conflict’
TAP-131 Clear ‘Software Download in Progress’
TAP-132 Clear ‘Incoming OC-48 APS Byte Fail’
TAP-133 Clear ‘SYSMEM Removed’
TAP-134 Clear ‘Clock Out of Range’
TAP-135 Clear (Optical Parameter) ‘Out-of-Range’
TAP-136 Clear Alarm When ‘NE ACTY’ and ‘FE ACTY’ LEDs Are Off (Cannot
Log in to a Network Element)
TAP-137 Clear ‘DS-NE Not Reachable’
TAP-138 Clear ‘Duplicate Node ID Defined’ or ‘Duplicate TID Defined’
TAP-139 Clear ‘Multiple DS-NEs Defined’
TAP-140 Clear ‘Node ID Conflict’
Table A – Numerical List of TOP Procedures (Note)
*
(Contd)