Lucent Technologies FT-2000 OC-48 - Page 936

IXL-001: Operation and Maintenance 365-575-102
Page 12 of 14 Issue 8.0, July 2002
FT-2000 MULTIPLEXER
TAP-141 Clear ‘Ring Incomplete/Open’
TAP-142 Clear ‘Ring Startup in Progress’
TAP-143 Address ‘Extra Traffic Preempted’
TAP-144 Clear ‘Path TCA’, ‘Section TCA’, or ‘Line TCA’
TAP-145 Clear ‘Incoming OC-48 Invalid F Byte’
TAP-146 Address ‘Traffic Squelched’
TAP-147 Address Condition at Remote Repeater Bay/Shelf
TAP-148 Clear ‘CP (Unknown Type) Removed’
TAP-149 Clear DRI Switch
TAP-150 Clear ‘APS Provisioning Conflict’
TAP-151 Address ‘CP Reset in Progress’
TAP-152 Clear ‘Inc. (From OC48) Sync Ref Fail’
TAP-153 Clear ‘STS3 Squelch Map Conflict’, ‘STS1 Squelch Map Conflict’, or
‘Squelch Map Conflict’
TAP-154 Address ‘TG Warming Up’
TAP-155 Clear Suspected Failure in FT-2000 Network Element(s) Via Remote
Modem (or Datakit
â
Network) Connection
TAP-156 Clear ‘DS3 Path Unequipped’
TAP-157 Clear ‘FT-LBA (Condition)’
TAP-158 Clear ‘OC3/OC12 Mode Conflict (Equipment, Slot Pair, X-Connect)’
TAP-159 Clear ‘CPYPGM:IP (tid)’
TAP-160 Clear ‘Incoming OC3 APS Byte Fail’ or ‘Incoming OC12 APS Byte Fail’
TAP-161 Clear ‘Circuit Audit Suspended’
TAP-162 Clear ‘Circuit Provisioning Error’
TAP-163 Clear ‘Path Integrity Failure’
TAP-164 Clear ‘STS1 Squelch Map Conflict’
TAP-165 Clear ‘STS3 Squelch Map Inconsistent’ or ‘STS1 Squelch Map
Inconsistent’
TAP-166 Address an Unexplained Loss of Service
TAP-167 Clear Potential Loss of Service Due to Double Failure
TAP-168 Clear ‘Incoming OC48 APS Default Byte’
TAP-169 Address ‘Inc. (from OC3) DCC Failure’ or Address ‘Inc. (from OC12)
DCC Failure’
TAP-170 Address ‘TID Address Map Full’
TAP-171 Restore Network Element Operation After Power Loss
TAP-172 Clear ‘NE Status Comm Failure’
TAP-173 Clear ‘X-Conn Provisioned But Not Est’
Table A – Numerical List of TOP Procedures (Note)
*
(Contd)