Lucent Technologies FT-2000 OC-48 - Page 937

365-575-102 Operation and Maintenance: IXL-001
Issue 8.0, July 2002 Page 13 of 14
FT-2000 MULTIPLEXER
TAP-174 Clear ‘Incoming (From OC-48) STS LOP’
TAP-175 Clear ‘LCLAN Failure’
Detailed Level Procedures (DLP) Tab
IXL-001 Task Index — Detailed Level Procedures
DLP-500 Make Manual Optical Loopback at FT-2000 Network Element
DLP-501 Connect and Condition Craft Interface Terminal (CIT)
DLP-502 Perform Local Automatic Turnup Test
DLP-503 Perform Automatic Low-Speed Cabling (Fiber) Test
DLP-504 Perform Provisioning Test Office Alarm Operation
DLP-505 Perform Provisioning
DLP-506 Verify FT-2000 Network Element Is Connected
DLP-507 Turnup Test - Point-to-Point System
DLP-508 Test Parallel Telemetry
DLP-509 Test Serial Telemetry
DLP-510 Clean Optical Fibers and Connectors
DLP-511 Remove/Replace Shelf Cover
DLP-512 Install/Remove Lightguide Buildout
DLP-513 Test Fan Assembly (ED-6G992-30)
DLP-514 Remove and/or Install Circuit Pack
DLP-515 Replace Fuse in Power Distribution and Fuse Panel or User Panel
DLP-516 Obtain State Report
DLP-517 Provision Low-Speed Slot and Port Parameters
DLP-518 Temporarily Remove High-Speed Optical Loopback(s) at FT-2000
Network Element
DLP-519 Install and/or Remove Optical Loopback at OC48 REGENR Circuit
Pack
DLP-520 Properly Terminate DS3 and/or EC1 Outputs
DLP-521
Establish Modem or Datakit
â
Network Access
DLP-522 Change, Delete, or Enter a User’s Login
DLP-523 Release Looped Back DS3 and/or EC1 Circuit(s)
DLP-524 Establish or Disconnect Remote Login Using CIT
DLP-525 Loop Back DS3 and/or EC1 Circuit(s) for Testing
DLP-526 Replace Fan Filter (in E-Bay)
DLP-527 Replace Circuit Pack With Different Circuit Pack
DLP-528 Inspect (Repair) Optical and/or Electrical Cable(s)
Table A – Numerical List of TOP Procedures (Note)
*
(Contd)