IXL-001: Operation and Maintenance 365-575-102
Page 14 of 14 Issue 8.0, July 2002
FT-2000 MULTIPLEXER
DLP-529 Introduction to the PC
DLP-530 Test Miscellaneous Discrete Telemetry
DLP-531 Provision STS-1 Path Trace
DLP-532 Verify STS-1 Path Trace
DLP-533 Install/Remove Apparatus (Circuit Pack) Blank
DLP-534 Verify That Low-Speed Ports Are Not NMON
DLP-535 Identify Source of Incoming Signal
DLP-536 Enter/Delete/Edit STS-3 (or STS-1) Cross-Connections at Network
Elements for 2-Fiber Ring Network
DLP-537 Enter/Delete/Edit Limited Granularity STS-1 Cross-Connections in
Network Elements for 2-Fiber Ring Network (for Rel. 6 and Earlier)
DLP-538 Loop Back OC-3 Line(s) for Testing
DLP-539 Release Looped Back OC-3 Line(s)
DLP-540 Provision OC3 Slot for 1-Way Drop Service
DLP-541 Test DRI Cross-Connections for Path Integrity in FT-2000 Ring
DLP-542 Enter/Delete DCC Assignment on OC-3/OC-12 Line
DLP-543 STS3 (or STS1) Path Trace Monitor for Non-DS3 Signals
DLP-544 Enter or Change TID String of FT-2000 Network Element
DLP-545 Replace Fan Filter Every Six Months (in D-Bay)
DLP-546 Replace Defective Fan Unit in D-Bay
DLP-547 Provision OC12 Slot for 1-Way Drop Service
DLP-548 Release Looped Back OC-12 Line(s)
DLP-549 Loop Back OC-12 Line(s) for Testing
DLP-550 Replace a Defective Power-Line Filter
DLP-551 Power Down/Power Up an Optical Network Element
* Table A is provided as a reference only and should not be used alone in finding instructions for
performing tasks.
Table A – Numerical List of TOP Procedures (Note)
*
(Contd)
To Next Page
Loading...