365-575-102 Acceptance:
Issue 8.0, July 2002 Page 1 of 2
NTP-010
Accept Added Optical Low-Speed Fibers to an
In-Service FT-2000 Network Element
DO ITEMS BELOW IN ORDER LISTED . . . . . . . FOR DETAILS, GO TO
1. Overview: This acceptance procedure is used to test new optical
low-speed fibers between an in-service FT-2000 network element and
the corresponding lightguide cross-connect panel or other terminating
equipment.
Required Test Equipment:
Craft Interface Terminal (CIT)
Wrist Strap
!
WARNING:
Unterminated optical connectors may emit invisible laser radiation. Eye
damage may occur if the beam is viewed directly or with improper optical
instruments. Avoid direct exposure to beam.
!
CAUTION:
Use a static ground wrist strap whenever handling circuit packs or working
on an FT-2000 terminal to prevent electrostatic discharge damage to
sensitive components. See "Electrostatic Discharge (ESD) Considerations"
in Trouble Clearing: TAD-100.
NOTE:
This procedure is only used if the new optical low-speed fibers were
installed by someone else. If the installation has not been completed
(including associated circuit pack installation), notify the installation
personnel or refer to 365-575-115 to complete the installation.
If you
completed the installation following the procedures in the installation
manual, do not perform this procedure
.
To Next Page
Loading...
Need help?
General