365-575-102 Circuit Order: NTP-002
Issue 8.0, July 2002 Page 3 of 4
Circuit Order: NTP-002---+---DLP-536
|---TAD-100
|---DLP-501
|---DLP-511
|---DLP-533
|---DLP-514
|---DLP-517
|---DLP-534
Install DS3 or STS1E circuit pack(s) into the
specified slot(s) of the low-speed shelf per the circuit
order.
DLP-514
8. Verify the FAULT LED on each DS3 or STS1E circuit
pack(s) goes off within 1 minute after the circuit pack
is installed.
—
9. Replace the shelf cover. DLP-511
10. Make the appropriate external cross-connections at
the DSX-3 or equivalent.
—
11.
NOTE:
Signal degrade provisioning for the STS1E circuit pack is done for all three
ports at the same time. For the DS3 circuit pack, it is done for one port at a
time.
If required, provision the DS3 or EC1 port
parameters.
DLP-517
12. Verify that none of the low-speed ports being added
were inadvertently left in the NMON state.
DLP-534
13. The DS3 or EC1 low-speed port(s) is now ready for
service.
—
DO ITEMS BELOW IN ORDER LISTED . . . . . . . . FOR DETAILS, GO TO
To Next Page
Loading...
Need help?
General