90-824052R3 JUNE 2002 IMPORTANT INFORMATION - 1C-7
DECAL APPLICATION
1. Mix
1
/
2
ounce (16 ml) of dish washing liquid in one
gallon (4 l) of cool water to use as wetting
solution.
NOTE: Leave protective masking, if present, on the
face of decal until final steps of decal installation. This
will ensure that the vinyl decal keeps it’s shape during
installation.
2. Place the decal face down on a clean work
surface and remove the paper backing from
“adhesive side” of decal.
3. Using a spray bottle, flood the entire “adhesive
side” of the decal with the pre-mixed wetting
solution.
4. Flood area where the decal will be positioned
with wetting solution.
5. Position pre-wetted decal on wetted surface and
slide into position.
6. Starting at the center of the decal, “lightly”
squeegee out the air bubbles and wetting solu-
tion with overlapping strokes to the outer edge of
the decal. Continue going over the decal surface
until all wrinkles are gone and adhesive bonds to
the cowl surface.
7. Wipe decal surface with soft paper towel or cloth.
8. Wait 10 - 15 minutes.
9. Starting at one corner, “carefully and slowly” pull
the masking off the decal surface at a 180° angle.
NOTE: To remove any remaining bubbles, pierce the
decal at one end of the bubble with stick pin and
press out the entrapped air or wetting solution with
your thumb (moving toward the puncture).
To Next Page
Loading...
Need help?
General
