Interconnecting the System
5-20 Hardware Installation
D510 System
Figure 5-20 Plug Connections for D510 PC Workstation
Note For Single Display systems, the Main Display is plugged into the 9-pin Main Display
connector on the rear of the D510 PC.
For Dual Display systems, a Dual Video Card and Y-Cable are required. The Y-Cable plugs
into the 9-pin Display connector on the Dual Video Card. See Figure 5-20. The Main Display
then plugs into the Y-Cable connector labeled 1 and the Second Display plugs into the Y-
Cable connector labeled 2. The rear panel Main Display connector is not used.
Caution Single Display systems must not have a Dual Video Card installed. The Main Display
connector must be used.
Mouse
Keyboard
UPS
Main Display*
Printer Clinical Network
Speaker
4-Channel
Recorder
(Optional)
Y-Cable*
SDN
2-Channel
* See Note
Recorder Rack
(Single Display)
(Dual Display)
-
Hospital LAN NIC Card
(Optional)
-
To Dual Video
Card Connector
(1) To Main Display
(2) To Second Display
To Next Page
Loading...
