Troubleshooting
7-58 Maintenance, Troubleshooting, and Repair
Revision The Revision window displays the following revision information:
Mainframe Serial Number
EEPROM Part Number
Software Part Number
Revision Number
Slot Number
Boards in the Mainframe: Slot, Type, Hardware Part Number, Firmware Revision
Receivers for the Mainframe: Slot, Type, Hardware Part Number, Firmware
Revision
Configuration The Configuration window displays the following configuration information:
SDN Unit Number
SDN Branch Numbers
Language
Transmitter Button
Auto Self Test (on/off)
Self Test Strip (on/off)
GENERAL ALARM PARAMETERS: Alarm Suspend Time, Alarm Reminder
GENERAL ECG PARAMETERS: HR Alarm Limits, Lead Fallback, Extended
Monitoring
Transmitters The Transmitters window displays the following information for telemetry transmitters:
M1400X series transmitters: Bandwidth, Lead Selection, Lead Label, Lead
Swap (on/off)
M26xxx series transmitters: Bandwidth, Lead Selection, Lead Label, SpO2
Alarm Limits
ST Parameters The ST Parameters window displays the following information for ST measurements:
General ST Parameters: ST Module (Enabled/Disabled), ST Alarm Limits
Measurements (ms): ST Module (Enabled/Disabled), ST Alarm Limits
Error Log The Error Log window displays the following current Error Log information:
Error Log Information: Card ID, Device ID, Slot, Error Code, Fatal (Yes/No),
Time, Date
A Clear Error Log button is also provided for erasing Error Log information for the
currently selected telemetry mainframe.
NBP Alarm The NBP Alarm window displays the following Teleframe Settings for NBP Alarms:
NBP Parameter: NBP Param (Enabled/Disabled), Diastolic Alarm (Enabled/
Disabled), Systolic alarm (Enabled/Disabled)
Diastolic Alarm Limits (High, Low)
To Next Page
Loading...
Need help?
General