Troubleshooting
Maintenance, Troubleshooting, and Repair
7-153
Step 3. When the confirmation ID number is entered, click Next.
Figure 7-66 OS Activation Complete
Step 4. Click Finish to complete the activation.
Step 5. On Simplified Chinese installations only: the date format must be manually
configured. To configure the date format, on the Database Server (or M3150 on local
database systems), to the Control Panel, and open Regional Options. In the Data
section, select a long date format that does not show Chinese characters. Press ok to
exit Regional Options.
Note If an ELO Touch display is connected, it must be recalibrated. See “Touch Display
Calibration” on page 5-26 for the procedure.
Application
Software
The installation procedure is given in the following steps.
Step 1. Modify the hostname and/or IP Address (via Control Panel -> Network) if
necessary. Reboot the PC.
Step 2. On the Database Server only: when the Server comes back online, double-click the
IIS Configuration icon on the desktop. This automatically configures all the IIS
settings.
Caution On M3154 Database Servers, make sure to run the IIS Configuration before installing
the application software. If IIS Configuration is not run, a complete OS installation
will need to be done.
Step 3. Insert the Application Software CDROM into the CD drive of the device.
With the application software CDROM inserted, Philips application software can be
installed.
Step 4. Browse to the CDROM Directory and double-click the mastersetup icon.
To Next Page
Loading...
Need help?
General