Network Names and IP Addresses
Hardware Installation
5-37
Note When selecting a Host Name, refer to the Note on page 5-34 for Host Names.
Step 4. To set the IP Address, click on Start->Settings->Network Connections.
Step 5. Right-click on the Monitoring LAN icon, and select Properties.
Step 6. Highlight the TCP/IP in the Protocols window and click on Properties brings up
the Internet Protocol TCP/IP Properties window of Figure 5-34
Step 7. Enter an IP Address for this device using one of the Recommended IP
Addresses for that type of device given in Table 5-1.
Step 8. Enter a Default Gateway for this device:
For Information Centers and Clients, use the IP Address of the Server.
For the Server, use the factory default value.
Step 9. Click OK to close the TCP/IP Properties window, OK again to close the Network
window, and then close the Control Panel to return to the Desktop.
Step 10. Shutdown and Restart the device to return to the Windows Main Menu.
Note After all Host Names have been changed, Database Server and all connected Information
Center/Client software must be reinitialized. See Software Reinitialization on page 6-5.
After setting Host Names and IP Addresses, Network Interface Card (NIC)
configurations must also be verified. The following steps give the procedure for NIC
configuration for the various model Information Centers and Client PCs.
Step 11. Click on Start, Settings and Control Panel to reopen the Control Panel
window.
Step 12. Double click on the Network Connections icon to reopen the Network
Connections window of Figure 5-33.
To Next Page
Loading...
Need help?
General