Configuration
6-60 Software Installation & Configuration
Step 3. Verify the performance of each Information Center and Client connected to the
Network using the procedures described in “Testing Product Assurance” on
page 8-1.
When the Product Assurance Tests are complete:
Step 4. Go to the Database Server and open the Service window.
Step 5. Click on Archive in the Configuration menu.
Step 6. Archive system configuration settings.
Step 7. Return to the Service window.
Step 8. Click on Print Configuration in the Configuration menu.
Step 9. Print the configuration settings for all device on the Network.
Step 10. Return to the Service window.
When the Database Server reboots, the Network/Server system will be in operating mode
Step 11. If 3 or more Database Servers are connected, each Database Server must restart
the IIS Service by entering the Service Shell, and going to Maintenance -> Restart IIS
Service. If this is not done at this time, Patient Data may not be visible across all
Database Servers using the Web Access feature.
Note Restart IIS Admin Service must be run after all Database Servers are configured and in
monitoring mode. Running this utility does not cause the Database Servers and connected
Information Centers and Clients to go into Local Database Mode.
The software installation and configuration process is now complete.
CONGRATULATIONS!
The Network/Server system can now be used for patient monitoring by all patient monitors
connected to the Network. Patient data will be stored on the Database Server and all patient
data review applications are fully operational.
To Next Page
Loading...
Need help?
General