EasyManuals Logo

Philips IntelliVue Series User Manual

Philips IntelliVue Series
522 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #429 background imageLoading...
Page #429 background image
Troubleshooting
Maintenance, Troubleshooting, and Repair
7-143
Step 5. Verify the Write Policy settings as follows:
a. Select Objects in the Management Menu and Enter.
b. Select Logical Drive and Enter.
c. Select Properties and Enter.
d. Select Write Policy and Enter.
e. Select WRBACK and Enter.
f. Press the keyboard Esc key until the Object Menu appears.
Step 6. Verify the SCSI Transfer Rate settings as follows:
a. Select SCSI Channel in the Object Menu and Enter.
b. Select Channel 0 and Enter.
c. Select SCSI Transfer Rate and Enter.
d. Select ULTRA-3 and Enter.
e. Select YES and Enter.
f. Press the keyboard Esc key until the Management Menu appears.
Step 7. Verify disk settings as follows:
a. Select Initialize in the Management Menu and Enter.
b. Select Logical Drive 0 and press the keyboard Spacebar.
c. Press the keyboard F10 key to start the initialization.
d. Select YES in answer to Initialize Drive? and Enter.
e. Press any keyboard key when the prompt appears at the bottom of the screen.
Step 8. Press the keyboard Esc key to return to the Management Menu.
Step 9. Press the Esc key again.
Step 10. Select YES in answer to Exit? and Enter.
Step 11. Reinstall Windows Operating System and Philips Application software
following procedures provided in this chapter.
For the HP D5000 Net Server LH3:
Step 1. Shutdown and Restart the Server.
During the power restoration cycle, NetRAID firmware initializes. When the Firmware
Initializing message appears on the bottom of the screen:
Step 2. Press the keyboard Ctrl-M keys simultaneously to enter the Net RAID Express
Tools application.
Step 3. Delete current RAID configurations as follows:
a. Select Configure in the Management Menu using the up/down arrow keys and
press Enter.
b. Select Clear Configuration and Yes, and then Enter to clear the RAID
configuration.
Step 4. Setup the Logical Drive as follows:
a. Select Configure in the Management Menu and press Enter.
b. Select View/Add/Delete Configuration and Enter to bring up the View/Add
Configuration ARRAY SELECTION MENU.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Philips IntelliVue Series and is the answer not in the manual?

Philips IntelliVue Series Specifications

General IconGeneral
BrandPhilips
ModelIntelliVue Series
CategoryServer
LanguageEnglish

Related product manuals