Troubleshooting
Maintenance, Troubleshooting, and Repair
7-155
Step 12. Click Next> and the Installing PIC Software window opens.
Step 13. Click N
ext> to begin the installation.
Step 14. When the software process is complete, the Config Wizard begins and sequences
through the required configuration windows for the device. See “Configuration” on
page 6-9.
Note If restoring, all settings will be restored using the Archive disk created before the OS
installation. The only setting that must be manually configured is the Patient Data Transfer
Bandwidth Utilization. See “Patient Data Transfer - Bandwidth Utilization” on page 7-75.
To Next Page
Loading...
