IntelliVue Information Center Demo Mode Software Installation
Demo Mode Installation Procedure
F-3
Your systems host name must be set to DEMO to use the configuration
provided. This archive file uses friendly bed labels in a 16 patient 8x2 format
(see sample screen).
All systems have 24 hours of data for retrospective review applications. The
two patient sectors (Archive 1 & 2) also have alarm review data.
Note To change the number of beds being displayed in Demo Mode it is
recommended not to change the number of patients! This will erase all the
data and settings. Use the Bed Config Setup Sector Layout - go to Bed Config
and change the number of patients; e.g., from 16 to 12 (see sample screen
below).
To run the Demo Mode simulator files, go to the Desktop window and double-
click on the RunDemo icon which has been installed on the screen.
Bed Label Type of Bed/Simulator
TeleB1 - TeleB3 Telemetry
EASIB1 - EASIB3 EASI Telemetry
Alarm1 - Alarm2 SDN in Alarm with Alarm Review Data
Bed4 - Bed7 SDN
Bed11,12,14 SDN
To Next Page
Loading...
Need help?
General