Risco ProSYS series - Page 219

ProSYS Installation and Programming Manual 219
EVENT MESSAGE DESCRIPTION
FORCED P=X
Partition X is force armed
FOUND Z=XXX
Wireless zone found, zone XXX
FUNC=XX C=YY
Quick key function XX by user YY
GSM:BATTERY
OK
GSM battery OK
GSM:GPRS PW
ERR
Authentication password is incorrect
GSM:GPRS PW
OK
Authentication password is correct
GSM:IP OK
IP connectivity OK
GSM:IP
TROUBLE
IP connectivity trouble
GSM:LOW
BATTERY
Low battery power from the GSM back-up battery (below 11VDC)
GSM:MAINS OK
Main power to the GSM/GPRS module is OK
GSM:MDL
COMM. OK
Internal GSM/GPRS BUS Module trouble restore
GSM:MODULE
COMM
Internal GSM/GPRS BUS Module trouble
GSM:MS OK
GPRS communication to the MS is OK
GSM:MS
TROUBLE
GPRS communication failure to the MS
GSM:NET AVAIL.
GSM Network is not available.
GSM:NET
AVAIL.OK
GSM Network is available.
GSM:NET
QUAL..OK
The GSM RSSI level is OK (according to the defined level)
GSM:NET
QUALITY
The GSM RSSI level is low(according to the defined level)
GSM:NO MAINS
No power from mains
GSM:NO PSTN
No PSTN line to the GSM module
GSM:PIN CODE
ERR
PIN code entered is incorrect
GSM:PIN CODE
OK
PIN code entered is correct.
GSM:PSTN OK
PSTN available
GSM:PUK CODE
ERR
PUK Code required
GSM:PUK CODE
OK
PUK Code is OK
GSM:SIM OK
SIM card is available.