STRASBAUGH, INC.
7AF SECS/GEM Interface Ver. 1.9 February 19, 2002 5-9
Strasbaugh Confidential
5-9
The Operator may issue the ABORT commands while in Remote. These commands will generate an OperatorCommand
event (CEID 11) as well as other messages attached to these activities.
5.2.2 Power Up
At Power Up, the Equipment Constant INITCONTROLSTATE (VID 41) controls whether ControlState is initialized to
ONLINE or OFFLINE. Within the Off-Line super-state, the Equipment Constant OFFLINESUBSTATE (VID 42)
controls whether the Control State defaults to:
1. Equipment Off-Line
2. Host Off-Line
3. Attempt On-Line
If INITCONTROLSTATE (VID 41) initializes to On-Line, the variable ONLINESUBSTATE (VID 44) determines
whether the default state is:
4. Local
5. Remote
5.2.3 Related Variables
The following table lists the variables (SV's, EC's, or DVVALS) which are relevant to the Control State. For a more
complete description of these variables, see "Appendix A --Variables".
Table 11 Control State Related Variables
Variable Name VID
INITCONTROLSTATE 41
OFFLINESUBSTATE 42
ONLINEFAILED 43
ONLINESUBSTATE 44
CONTROLSTATE 257
PREVIOUSCONTROLSTATE 242
5.2.4 Related Events
The following lists the collection events (CEIDs) which are relevant to the Control State. For a more complete
description of these events, see "Appendix B -- Collection Events" or the description in this chapter.
Table 12 Control State Related Collection Events
Collection Event CEID
CONTROLSTATELOCAL 13
CONTROLSTATEREMOTE 14
EQUIPMENTOFFLINE 5002
5.3 Process States
The processing of material at the Equipment is depicted through two Finite State Diagrams. The Equipment State diagram
illustrates the state of the Equipment in relationship to overall factory production. The 7AF Process State Diagram
illustrates in greater detail the processing at the 7AF.
To Next Page
