STRASBAUGH, INC.
5-12 February 19, 2002 7AF SECS/GEM Interface Ver. 1.9
Strasbaugh Confidential
5.3.1.1 E10 STATE TRANSITIONS
Table 13 E10 State Transitions
# From Trigger To Description
1 Unknown Power-up Standby
(VID 17 = 5)
Upon Power-up, the Equipment
defaults to this state.
2 Standby Operator
Request
Productive
(VID 17 = 6)
The operator has made a valid request
to start processing product and the
Equipment has complied.
3 Productive Information for
Operator
Unacknowledged
Assistance Request
(VID 17 = 3)
The Equipment has determined that
there is information needed by the
operator to take the next action and is
requesting assistance with the audio
alarm. The machine is no longer
processing product.
4 Assistance Request Information
Acknowledged
Standby
(VID 17 = 5)
The operator has responded to the
information displayed.
5 Standby Fault occurs Unacknowledged Fault
(VID 17 = 1)
The Equipment is notifying the operator
that a fault has occurred and is
requesting assistance with the audio
alarm.
6 Fault Fault is cleared Standby
(VID 17 = 5)
The fault has been cleared. Either the
Equipment was not processing product
or the fault was severe enough to
terminate processing of product.
7 Productive Fault occurs Unacknowledged Fault
(VID 17 = 1)
The Equipment is notifying the operator
that a fault has occurred and is
requesting assistance with the audio
alarm. If the fault is severe enough, it
will terminate processing. If possible,
the Equipment will continue attempting
to clear the fault and continue
processing.
8 Fault Fault is cleared Productive
(VID 17 = 6)
The fault has been cleared. The
Equipment was able to clear the fault
and continue processing of product.
9 Standby Information for
Operator
Unacknowledged
Assistance Request
(VID 17 = 3)
The Equipment has determined that
there is information needed by the
operator to take the next action and is
requesting assistance with the audio
alarm.
10 Unacknowledged
Assistance Request
Operator
Acknowledges
Information
Acknowledged Assistance
Request
(VID 17 = 4)
The operator has acknowledged the
information presented, but there is
further action to be taken. Processing of
product is not occurring.
11 Unacknowledged
Fault
Operator
Acknowledges
Fault
Acknowledged Fault
(VID 17 = 2)
The operator has acknowledged the
Fault presented, but the fault has not
been cleared. Processing of product is
not occurring.
To Next Page
