STRASBAUGH, INC.
6-18 February 19, 2002 7AF SECS/GEM Interface Ver. 1.9
Strasbaugh Confidential
6.43 S2F43 - Reset Spooling Streams and Functions
S2F43 W * H -> E
<L
<L [2]
<U1 STRID> * Message Stream
<L
<U1 FCNID> * Message Function
...
>
>
...
> .
The Host sends message to specify which messages the Equipment should spool in the event of a communications loss.
When this message is received by the Equipment, all previous definitions of messages to spool are replaced.
The following version of S2F43 will enable spooling for all messages within the specified stream:
S2F43 W * H -> E
<L
<L [2]
<U1 STRID> * Message Stream
<L>
>
...
> .
To disable spooling of all messages, the following version of S2F43 may be used.
S2F43 W * H -> E
<L>.
Spooling is not allowed for even-numbered function messages (replies) or stream one messages.
6.44 S2F44 - Reset Spooling Acknowledge
The S2F44 message has two forms, depending on the return code in RSPACK. If there are no errors in S2F43, the format
of S2F44 is as follows.
S2F44 * H <- E
<L [2]
<B [1] 00> * RSPACK
<L>
> .
If S2F43 contains any errors, the Equipment will discard the entire S2F43, and return error information is S2F44, as
follows:
To Next Page
