Strasbaugh nTellect 7AF - Page 1557

STRASBAUGH, INC.
7AF SECS/GEM Interface Ver. 1.9 February 19, 2002 8-11
Strasbaugh Confidential
8-11
246 SV U4 List
ALARMSSET - A list of all Alarms that are currently in the SET (on) state.
The format is as follows:
<L
<U4 ALID>
. . .
>
247 SV U4 List
EVENTSENABLED - A list of all EVENTS which are currently enabled.
The format is as follows:
<L
<U4 ALID>
. . .
>
248 DV U1
ALARMSTATE - The Alarm State for the most recently transitioned alarm.
0 = Alarm transitioned OFF.
1 = Alarm transitioned ON.
249 SV U4
SPOOLCOUNTACTUAL - A count of the number of messages actually
present on the spool disk, adjusted for any messages which have been
overwritten or otherwise discarded.
250 SV U4
SPOOLCOUNTTOTAL - A count of the number of messages the
equipment attempted to write to the spool disk. This number includes
messages actually present on the spool disk, and also any messages which
have been overwritten or otherwise discarded.
251 SV A[16]
SPOOLFULLTIME - The date and time at which the spool file became full.
The format is YYYYMMDDhhmmsscc. See the description of the CLOCK
variable above for format details.
252 SV U1
SPOOLLOADSUBSTATE - The current state of the SPOOL LOAD
superstate.
1 = Spool Active
2 = Spool Inactive
253 SV A[16]
SPOOLSTARTTIME - The date and time at which the first message was
written to the spool file. The format is YYYYMMDDhhmmsscc. See the
description of the CLOCK variable above for format details.
254 SV U1
SPOOLSTATE - The current spool state within the POWER ON superstate.
3 = Purge Spool
4 = Transmit Spool
5 = No Spool Output
255 SV U1
SPOOLUNLOADSUBSTATE - The current spool state within the SPOOL
UNLOAD superstate.
6 = Spool Not Full
7 = Spool Full
256 SV BOOLEAN
SPOOLFULL - The full state of the spool.
0 = Not Full
1 = Full
257 SV U1
CONTROLSTATE - The current Control State.
1 = Off-Line/Equipment Off-Line
2 = Off-Line/Attempt On-Line
3 = Off-Line/Host Off-Line
4 = On-Line/Local
5 = On-Line/Remote
258 DV U1
ECIDCHANGE - The VID of the Equipment Constant most recently
changed.
259 DV U4
GemLimitsVID. At any Limits Monitoring event this variable contains the
VID of the variable which crossed a boundary.
260 DV U4
GemEventLimit. At any Limits Monitoring event this variable contains the
Limit ID of the boundary crossed.