Strasbaugh nTellect (Model 7AF) Wafer Grinder
11 - 10 Version 1.2 - June 2004
I. BEFORE YOU BEGIN
Tools Required
• 5/32-in. hex key
• 3/16-in. hex key
Complete the Grinding Area Cabinet Base Leveling Procedure
If the cabinet base has not yet been leveled, follow the procedures found in the
Installation chapter of this manual to complete the Grinding Area Cabinet Base
Leveling Procedure (refer to Leveling the Two Machine Sections).
Turn Machine Power OFF
Follow the procedures found in the Operator Functions chapter of this manual.
Confirm that Air Is ON
If needed, follow the procedures found in the Operator Functions chapter of this
manual to turn air ON.
To Next Page
Loading...
