Strasbaugh nTellect (Model 7AF) Wafer Grinder
11 - 70 Version 1.2 - June 2004
I. BEFORE YOU BEGIN
Tools Required
none
Complete the Handling Area Cabinet Base Leveling Procedure
If the cabinet base has not yet been leveled, follow the procedures found in the
Installation chapter of this manual to complete the Handling Area Cabinet Base
Leveling Procedure (refer to Leveling the Two Machine Sections).
Confirm that the Handling Section Is Tightly Joined to the Grinding Section of the
Machine:
Upon completion of the Handling Area Cabinet Base Leveling Procedure the two
machine sections should have been joined.
• If needed, tighten the two wing nuts of the two fastening setscrew and wing
nut pairs (located at the right side of the machine behind door 17) to secure the
grinding section of the machine firmly to the handling section by rotating them
clockwise manually.
To Next Page
Loading...
