Strasbaugh nTellect (Model 7AF) Wafer Grinder
11 - 156 Version 1.2 - June 2004
G. TEST THE NEW POSITIONING
1. Power up the machine.
2. Repeat Section B., above.
a. If the goal is met for all four turrets, skip to When Satisfactory Adjustment
Is Achieved, below.
b. For any sensor still not meeting the goal, repeat the adjustment procedure,
moving the affected sensor toward the middle of the actuator in 1/8-in.
increments, moving the sensor(s) and retesting until the goal is met.
H. WHEN SATISFACTORY ADJUSTMENT IS ACHIEVED
1. Close all doors.
2. Power up and home the machine.
To Next Page
Loading...
