Strasbaugh nTellect (Model 7AF)Wafer Grinder
2 - 8 Version 1.2 - June 2004
e. Replace the three 3/8-16 screws removed earlier.
f. Using the six 1/4-20 socket head screws removed from the shipping bracket,
install the two 1-in. x 3 1/2-in. x 1/2-in. bearing clamps at the rear of the bridge.
Rotate the socket head screws clockwise to firm.
4. Skip to Leveling the Two Machine Sections, below.
For Manufacturing Locations with a Narrow Access Door
(Greater than 50 Inches but Less than 70 Inches)
Consult the factory for customized procedures.
To Next Page
Loading...
