Operations and Maintenance Manual Pneumatic Adjustments
Version 1.2 - June 2004 13- 9
2. Remove the two 3/8-16 wing nuts and washers, located at the right side of the
machine behind door 17, which secure the grinding section of the machine to
the handling section:
a. Manually rotate each wing nut counterclockwise to loosen and
remove.
b. Remove the large washers.
Note: Do not remove the setscrews from the handling section.
3. Push down on the two black 2-inch exhaust duct tubes to disconnect them
from the grinding exhausts (their top connection).
Allow the duct tubes to rest at the top of the plenum connection.
4. Check for window frame loosening.
5. Push the handling section clockwise slightly, rotating it on its hinge, to permit
access to the flow controls, located on the conditioning arm cylinders which
are just inside the handling section.
Notes: Do not remove the hinge pin, located on the left side of the
handling section.
The handling section moves easily on two castors.
6. Rotate the knob on the regulator until the pressure gauge reads 60 PSI.
To Next Page
Loading...
