D950/Vista7 Digital Mixing System
Date printed: 27.08.03 SW V3.3 AutoTouch+ 5-89
VMC Switches: VMC oriented switches can be automated using AutoTouch+. These
switches are as follows:
• Channel Strip:
- Mute: Channel Mute
- Encoder Parameter Switches: The switch associated with each of
the four channel strip rotary encoders.
- Rotary Selectors: This also includes rotary encoders that are used as
Selectors. (See Selectors below)
- Processor Block In/Out Switches: EQ, FILT, COMP/LIM, EXP/GATE,
INSERT, DELAY, OPT, and PAN
- Auxiliary In/Out Switches: MONO 1...4 and STEREO 1...4
- Direct Out Switch: DIR OUT
- Input Selector Switches (See Selectors below): IN 1, IN 2, GEN
Note: Mono and stereo auxiliaries 5 and above may be engaged via the CAS or
CAU (Central Assignment Unit).
• CAS:
- Mute: Channel Mute
- Output Switch: DIR OUT, MT Bus Trim/N-1
- Input Selector and Parameter Switches (See Selectors below): IN 1,
IN 2, GEN
- Processor Block In/Out and Parameter Switches: EQ, FILT,
COMP/LIM, EXP/GATE, INSERT, DELAY, OPT, and PAN
- Rotary Selectors: This also includes rotary encoders that are used as
Selectors. (See Selectors below)
- Auxiliary In/Out and Pre Switches: MONO and STEREO
Note: A process must be included in the VMC in order for it to be automated. A
process has not been assigned to the OPT processing block position in
V3.0 or previous software.
Control Switches: Switches that are control oriented are outside the AutoTouch+ system and
therefore cannot be automated. Switches outside of the control of Auto-
Touch+ are as follows:
• Channel Strip:
- SEL Key: Channel Select key
- PFL/SOLO Key:
- Automation Switches: AUTO MODE, S/E PB – S/E REC, MUTE STAT,
FDR STAT
- Layer Switches: L1 and L2
- Clipboard Control Switches: CLR/••ALL, COPY/••ALL,
SWAP/••PASTE
- PAGE Switches: 1, 2, 3, 4
- TALK
- LAST/••FREEZE
- User Keys: USER 1, USER 2
- ASN SEL key: Assignment Select key (ASN ENC on D950 M2)
• CAS:
- Channel Selection Controls:
- PFL/SOLO key:
- Automation Switches:
- Clipboard Control Switches: CLR/••ALL, COPY/••ALL,
SWAP/••PASTE
- Auxiliary/Master/Panner Selection Controls: