D950/Vista7 Digital Mixing System
5-98 AutoTouch+ SW V3.3 Date printed: 27.08.03
Channel Patch items may be updated in the same manner as any other
Static control.
Note: The following Channel Patch items have switches on the channel strip that
duplicate the Channel Patch functions:
• Input Selector
• Dynamic Sidechain Link Enable
• Dynamic Key Input Routing
Note: The channel Meter location can be set globally using the controls in the
“Meter/Generator” item in the GC Options menu (not the AutoTouch+
Options selector).
Item Behavior: The Channel Patch does not have dedicated automation controls. The cur-
rent global automation modes apply to the Channel Patch.
The following Channel Patch items operate as Selectors:
• Input Selector
• Processor Block Order
• Dynamic Key Input Routing
• Direct Output Tap Location
• Meter Feed Tap Location
The SW (SWIT) Pre-Selectors are used to select global modes.
Press and Release Selectors: Some Channel Patch Selectors operate as Press and Release switches and
therefore follow Press and Release switch operation rules. Refer to chapter
5.10.3.1.
The following Channel Patch items operate as Press and Release Selectors:
• Input Selector
• Dynamic Key Input Routing
• Meter Feed Tap Location
Note: The channel Input Selector may be operated via the Channel Patch or by
using the keys on the channel strip. Since input selection is controlled with
a Selector, Press and Hold operations are not possible.
One Shot Selectors: Other Channel Patch Selectors operate as “One Shot” switches. One Shot
selectors operate as true momentary switches. The user has no control over
the duration of the held down state and release is immediate. A One Shot
operation produces both a Touch and a Un-touch event. In TOUCH
RECORD, when a One Shot switch is operated, punch-in and punch-out is
almost immediate. Under normal circumstances this could produce an
audible glitch, depending on the operation being completed. However,
functions assigned to One Shot Selectors will persist in their changed state
after punch-out. All Mix Pass “Write To:” and “Extend Back To:” condi-
tions apply, except “Write To : Punch Out.”
The following Channel Patch items operate as One Shot Selectors:
• Processor Block Order
• Direct Output Tap Location
These items follow the rules for One Shot Selectors as described above.
To Next Page
Loading...
Need help?
General
