D950/Vista7 Digital Mixing System
Date printed: 27.08.03 SW V3.3 AutoTouch+ 5-137
Timecode addresses may be entered into all three fields in the following
ways:
• Capture the current timecode address using the “In” or “Out” buttons (if
provided);
• Highlight all or part of the entry field and type in the address;
• Highlight all or part of the entry field and click/drag (roll) the value up
or down;
• Press the “+” or “–“ key from the computer keyboard, and an additional
Timecode Entry Field will appear. The value entered into this field will
be added (+) or subtracted (–) from the existing timecode value.
• Right-Click any part of the entry field and a menu of timecode address
selections from which to choose will appear;
Note: Refer to chapter 5.16.4 for additional details regarding timecode entries.
The In Time and Out Time entry fields are equipped with buttons that al-
low the capture of the current timecode address while the mix is stopped or
running. Clicking on these buttons will enter the current address into the
appropriate field.
Changes made to one of the entry fields may effect the address(es) of one
or both of the other fields. For example, changes made in the In Time or
Out Time fields will change the value of the Length time. Changes made in
the Length field will change the value of the Out Time.
The Length field may be frozen by checking the Lock box to its right.
When the Length field is locked, its value remains constant when changes
are made in the other fields. Changes made to the In Time will change the
Out Time and vice versa. It is important to note that the Length value may
be edited even when it’s locked.
Note: Timecode Entry Fields do not appear in the Active Mix box when Update
Snap is selected as the Edit Type.
To Next Page
Loading...
Need help?
General
