D950/Vista7 Digital Mixing System
5-186 AutoTouch+ SW V3.3 Date printed: 27.08.03
• <Set Pre-Selector Objects to WRITE>: Any controls that are selected in
the Control Modes Pre-Selector will be set to WRITE. All others will
be set to READ.
• <Set Pre-Selector Objects to TRIM>: Any controls that are selected in
the Control Modes Pre-Selector will be set to TRIM. All others will be
set to READ.
Mode Enable sets non-selected to READ:
Normally you can use the Pre-Selectors in combination with the Control
Mode activators to set various control types into different Control Modes.
For example, you could select FDR (only) and hit WRITE and the faders
will all go into WRITE. You could then hit CLR and ENCoders and then
hit TRIM and the knobs will be in TRIM, while the faders are in WRITE.
This is very flexible and useful, but if you want to ensure that only specific
controls are in a specific mode (like making sure that the Faders are in
WRITE and everything else is in READ), you would have to select all the
Pre-Selectors (or Hold down the CLR/ALL key) and hit READ. Then se-
lect FDR and Hit WRITE. However, when this option is set, you are al-
ways assured that when you hit an Control Mode activator, all control
NOT active on the Pre-Selectors will be set to READ when the selected
controls are set to the activator mode. For example, if only FDR selected
on the Pre-Selector and the TRIM activator is hit, it is assured that every
control other than faders will automatically be set to READ mode.
To Next Page
Loading...
Need help?
General
