D950/Vista Digital Mixing System
7-6 ConfigTool SW V3.3 Date printed: 05.08.03
• Temp Files Path, and
• Config Path,
for which the appropriate paths must be entered manually; they must be
followed by a backslash (\) sign.
After making the appropriate entries please click “OK” to finish the prepa-
rations and to store the edited “D950CfgTool.ini” file automatically. To
learn more about the use of the .ini file, please refer to chapter 7.5, Main-
tenance.
Test the Installation: Now that you have installed all files and set the basic options, you can
proceed to test the whole installation, by generating an empty configura-
tion. This empty configuration is loaded per default after starting the ap-
plication.
Select the menu item “Generate” and then “All”. This will start the process
of generating the DSP and control software that is needed to run a new
Session Configuration on your console. Various messages will be dis-
played, and after a while, a message similar to the following one should
appear:
After the message “Build All finished successfully !!” appears, click on
“OK” to finish the successful installation and test procedure.
To Next Page
Loading...
