Toptech Systems MultiLoad II User Manual

Chapter 13 – Custom Logic
400
Firmware Version 3/4.31.37
Parameter
Description
Gross Flow Rate
The current gross flow rate, measured from the
specified meter, for the current batch. The value is in
whole units.
Temperature
The current temperature reading associated with the
specified meter. The value is in hundredths, with an
inferred decimal.
Pressure
The current pressure reading associated with the
specified meter. The value is in hundredths, with an
inferred decimal.
Density
The current density reading associated with the
specified meter. The value is in tenths, with an inferred
decimal.
Relative Density
The current relative density reading associated with the
specified meter. The value is in ten thousandths, with
an inferred decimal.
API Gravity
The current API gravity reading associated with the
specified meter. The value is in tenths, with an inferred
decimal.
Gross Creep Delivery
The gross volume that has flowed through the specified
meter when there shouldn’t have been. Value is in
whole units.
Volume Preset
Indicates the target volume that is intended to flow
through the specified meter based off the value entered
in by the driver. Value is in hundredths with an implied
decimal.
Additive Real Time (RT)
Parameter
Description
Clearing Errors
Indicates that an additive-level alarm is clearing for a
particular additive.
Clear Batch
Indicates that additive totals of a particular injector are
being archived.
Test Button
Indicates that the Test Button used in injector
calibration has been pressed for a particular injector.
Pump Run
Indicates that a particular Additive’s pump has been
commanded to run.

Toptech Systems MultiLoad II Specifications

General

Brand	Toptech Systems
Model	MultiLoad II
Category	Control Unit
Language	English