Firmware Version 3/4.31.37
3 modes: Continuous push, Continuous push with scheduled periodic release,
Scheduled periodic releases.
All signals are added to the Bay Diagnostic screen.
New alarm added *DEADMAN.
01/01/2013 PS
New feature FKEYPADON and FKEYPADOFF, this gives the capability to disable the
keypad.
Stop button will still work to ensure driver can always stop the load
Also the Idle and the Menu screen are not keypad locked
Modbus commands added Reg 7008 and 7009
Copyright changed to 2013
01/02/2013 PS
Enhancement Default startup mode if keypad is locked or unlocked
01/02/2013 WJP
Added the ability for bol printing on Ethernet printers.
01/03/2012 PS
Add Bsw to Web interface Transaction View
01/04/2013 PS
Changed UNAUTH FLOW voucher that we take alibilog labels for GROSS and NET, also
remove approval chars
01/11/2013 PS
Added new bio ethanol API tables PTB Method 3 , for Products E5, E10, E80, E85,
E100, Benzin/Petrol, Diesel, B5 RME, B7 RME, B100RME, B5 SME ,
B7 SME, B100SME.
Corrected Density 15degrees has a fixed value for BIO components
Added picklist routines and read register for MultiMate
01/12/2013 PS
Enhancement UNAUTH FLOW Voucher will use the real-time unauth totalizer amount
instead of the clear amount on the component level.
This is to ensure the full amount is always on the alibilog.
01/15/2013 PS
Added rollover check to unauthorized flow voucher
New feature non-proportional ratio and side-stream blending, the component max
flow rate will be used to determine the high flow
The main component (highest percentage) which flow in low flow all other
component wait until the high flow start is reached.
Blend check is only done at the end of the load, during the load the product is
never in spec only at the end.
Fallback and flush feature are still working in the non-proportional
enhancements.
01/16/2013 PS
Added Time on Main Loading Screen for all devices except SMP
01/29/2013 PS
Added Alcohol Table Brazil NBR 5992
01/30/2013 PS
Fix double use of RCU Registers 79 and 80
To Next Page
Loading...