Firmware Version 3/4.31.37
Change firmware number to x.31.09
SD-card will save register 78, 79 and 80
Changed equipment database version to 3.31.09.
01/31/2013 PS
Added Hydrocarbon Table Brazil (LPG, Gasoline, Diesel, Lubes, Crude, Asphalt and
heavy oils)
01/31/2013 PS
Enhance sd card file lists to only display select extensions (.bmp, .mlc, .bin)
ignoring extension case.
Release 3/4.31.09
02/04/2013 PS
Enhancement of Deadman with bypass key, to disable deadman function without going
into program mode
02/11/2013 PS
Added API alarm timeout so, alarm would not raise after x time. Vcf stays the
last known value
Changed version number to x.31.10
02/15/2013 PS
Enhance UAP that Product Message is after each the product/component line
Swapped UAP Bol City line with Phone number line
Fix UAP Bol when more than 1 page, cursor would not follow the end of copy line
02/21/2013 WJP
Trim CRs and LFs from BOL script to prevent TDS communications from hanging on
message_log lines with CRs.
02/22/2013 PS
Enhancement of the Alarm Screens
Added new functionality that each status alarm
(bay,preset,meter,component,additive) can be hidden for any remote system.
2/26/2013 WJP
Added Driver Routines to read NVRAM Battery Monitor Voltage and Temperature.
Added Battery Monitor Service Routine to Check Battery Voltage every 24 hours.
2/26/2013 PS
Added new alarm routine which give all 32 bit alarm states.
New communication commands are added Bay(MRBA32),Preset(MRPA32, MRPA),
Meter(MRMA32), Comp(MRCA32), Add(MRAA32).
03/01/2013 PS
Enhancement of new Menu Level under Equipment Setup for settings up the MultiLoad
II
03/02/2013 PS
Add Deadman functionality also to Custom Logic
03/06/2013 PS
Enhancement on payload transaction to UAP. Added BSW and Pressure to the
transaction file.
To Next Page
Loading...