Firmware Version 3/4.31.37
Fixed relative sensor enabled in the W&M menu
08/02/2013 PS
Added support for printing W&M Logs to Network Printers
08/05/2013 WJP
Corrected check_fcm_analog_assignment() to allow multiple additives on the same
preset to share the same analog output.
08/08/2013 PS
Fix problem with non-proportional blending, that we allow straight loading of the
second product.
08/19/2013 WJP
Added saving/restoring of TDS/UAP configuration parameters (R106000-R106005) when
saving/restoring ML configurations to/from the SD card.
08/27/2013 WJP
Updated firmware version to 4.31.13.
Added BUCKET_DUAL_NONCAPTIVE and SLOT_DUAL_NONCAPTIVE card reader types.
Card_Inserted status will now return a '2' when a second card has been read while
a transaction is active.
Card_Inserted status will return to a '1' when the first card has been read again
while a transaction is active.
R962 (and Modbus 2900..2979) will return the first card data when Card_Inserted
is a '1', and the second card data then Card_Inserted is a '2'.
Reading a third card while the Card_Inserted status is a '2', will only update
the R962 register to the card data of the third card. The Card_Inserted status of
'2' will remain unchanged.
Update NR database version to 3.31.13.
08/28/2013 PS
Added in RCU Diagnostic the Hardware and Software Reboot Date and Time.
Date can be shown as MM/DD/YYYY or DD/MM/YYYY.
Fix standalone dual card processing.
08/29/2013 PS
Added new Bay *POWERFAIL Alarm.
Added this alarm to the Custom Logic Alarm Section.
Moved update hardware boot time, so it will be only updated when we have a real
hardware reboot.
08/29/2013 TF
Added new CTS/DTR test.
Added this test to the Serial Port Test section.
09/01/2013 PS
Enhancement change ratio and sequential register to 1 register picklist.
Added picklist to MultiMate communication protocol.
Rename all references to blending_type.
Enhancement that any configuration inputs can also be linked straight to the
custom logic parameter.
Update all communication protocol to read and write the new register option
Updated display routine to support custom logic linking
Split FCM_ADDRESS in FCM_ADDRESS_OUTPUT and FCM_ADDRESS_INPUT
Enhancement of the Mass Calculation Screen: Added Measured Used and Mass Measured
Used to the selection screen
To Next Page
Loading...