Firmware Version 3/4.31.37
Chinese language configuration prompt translations have been updated.
Fix W&M log software version number display.
Update preset current temperature to be set to zero if no flow. Previously was
last flowing blended temp.
Fixed Modbus register 955 Driver Name both read and write were misaligned.
10/2/2013 WJP
Added Facility Code to UAP Terminal Profile database.
Updated UAP script to verify card facility code if a facility code is specified
in the Terminal Profile.
10/3/2013 PS
In Meter Proving Mode the Minimum Preset Qty will be not checked, the Maximum
Preset is still checked.
10/7/2013 TF
Fix display of a filename in the SD card screens. Now it will only display as
much of the path as possible on one line. Previously was wrapping it around to
subsequent lines.
10/7/2013 PS
Removed Fcm-Trace Alarm under Bay Level and custom logic, because was not in use
anymore.
Rewrite Real Time Alarms under Custom Logic so we see the same alarm names as
under Alarm Setup.
Also all 32 Alarms are now available.
10/8/2013 TF
Fix renaming of SD card filename with an extension. If an extension is longer
than 20 characters user must re-enter it in manually.
10/8/2013 PS
Added in Factory Menu reset Capacity for Battery.
Added in Factory Menu check for Voltage and Temperature.
10/9/2013 PS
Fix: Default Processing Mode Invalid was out of range in the build.
Fix: If changing a custom logic line from one to another type we need clear the
previous setting.
Fix: In Additive Calibration Screen range check for vol_per_injection was not
working.
Fix: Command P enable picklist w/len, that the range is between 0 and Max
Columns.
Fix: DB routings out of range checking.
Remove net approval char for additive totalizer
Fix: Simulation Webpage should show unsigned values instead of signed.
Fix: Mass Calculator Volume is unsigned instead of signed.
Fix: Logmsg in prompt.c file are signed instead of unsigned.
Fix: MultiMate response for picklist values.
10/10/2013 PS
Fix: CN Bol Date range check was allowing zero.
10/13/2013 WJP
Updated Auto Batch authorize to work when current screen is load, control or any
status screen.
To Next Page
Loading...