Firmware Version 3/4.31.37
Fix: The automated reports had the potential of trying to create a filename length that
was too long for the CPU to handle. If the filename length was too long then a report could
not be created. The Terminal Name will now be truncated to only 15 characters (if needed)
when adding it to the filename.
Updated NR, NR3, NR4, and NR6 to version 3.31.23 (Totalizers will be reset on a firmware
upgrade).
06/09/2015 TF
Fix: Network Test Menu Display. If a user selected "Specify" to test a specific IP
address, the line on the screen wasn't cleared and the IP address was displayed twice on
the same line.
06/17/2015 TF
Fix: UAP Product Message Printing on BOL. If the Product Message contained more
characters than the MAX characters allowed per line then the message would wrap onto
subsequent lines which would overwrite other transaction details.
Fix: If Auto Authorized was enabled at the RCU Level, and the Card Reader Type was set to
SLOT or BUCKET then the MultiLoad could get stuck in the Load Screens. The user would then
have to power cycle the unit and reset factory defaults in order to be able to go back into
Program Mode to fix the configuration. Now if the card reader is not disabled and Auto
Authorize is enabled, the MultiLoad will log a message of the error and automatically set
the Card Reader Type to DISABLED.
06/17/2015 MS
Fix: Help screen now yields for configuration timer.
06/18/2015 TF
Added the ability to print the Message Log on command via the Views & Inquiries screen if
a printer is configured.
06/22/2015 TF
Added Display Preset Totalizers parameter to the SMP build.
06/25/2015 TF
Fix: Equipment Setup Sampler Selection. If a user selected a Preset other than 1
they would still see the Samplers associated with Preset 1. It would be impossible
to modify any parameters for samplers that were not associated with Preset 1.
Fix: MRTD Command. If there was a negative pressure value, the MultiLoad would
send a very large number back to the host system.
06/26/2015 TF
Increased firmware version to x.31.24
Fix: As soon as a batch is authorized the BSW Alarm Timer starts. The timer now starts
once flow has started.
06/27/2015 TF
Added a new parameter for SCS Line->"BSW Alarm Volume". This parameter is used to trigger
a BSW alarm after a configured amount volume has passed through the meter. If this
parameter is configured to anything other than zero, the BSW Alarm Timer will not be used.
06/29/2015 TF
Fix: BSW value was not being calculated if it went past the alarm range. If the
BSW went past the Alarm low or Alarm high range, the MultiLoad would not average
the bad value into the batch.
To Next Page
Loading...
