EasyManuals Logo

Zeiss Humphrey II-i series User Manual

Zeiss Humphrey II-i series
580 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
Humphrey Field Analyzer II-
i
series User Manual 2660021145640 A
Introduction & Instrument Setup
1-11
Product Compliance
0297
Complies with 93/42/EEC Medical Device Directive.
Complies with US and Canadian medical electrical system safety requirements.
Product Safety
This instrument is classified as follows:
Class I Equipment
– Protection against electrical shock.
Type B – Degree of protection against electric shock of applied part (chinand forehead rests,
and patient button).
Ordinary Equipment (IPX0)
Degree of protection against ingress of liquids (none).
Continuous Oper
ation – Mode of operation.
General Safety Requirements
Although the HFA II-
i
is designed for continuous operation, it should be turned off when not
used for an extended period of time. The HFA II-
i
should be used in a cool, dry dust-free setting.
Use the instrument cover to protect the HFA II-
i
at all times when it is not in use.
Do NOT place the cover over the instrument when the HFA II-
i
is turned on, as loss of proper
airflow can cause overheating and damage to sensitive components.
Do NOT connect or disconnect cables while power is on.
Do NOT place any objects on top of the instrument.
Do NOT place any container holding liquid near the instrument.
Use only a stand or table recommended by Carl Zeiss Meditec.
Warnings and Cautions
WARNING: Do NOT block the ventilation openings. These allo
w
for the release of
heat generated during operation. A buildup of heat due to ventilation opening
blockage can cause failures which may result in a fire hazard.
WARNING: To prevent electric shock, the instrument must be plugged into an earthed
ground outlet. Do not remove or disable the ground pin. Only an authorized Carl
Zeiss Meditec service representative may install the instrument.
WARNING: Do not use the printer or the instrument or the optional power table with
an extension cord or a power strip (multiple portable socket outlet). For additional
safety, do not plug the printer and the instrument (or the optional power table) into
the same wall outlet. Failure to observe this warning could result in electrical shock to
the patient and/or examiner.
WARNING: Do not open the instrument covers. Opening the instrument covers could
expose you to electrical and optical hazards.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Zeiss Humphrey II-i series and is the answer not in the manual?

Zeiss Humphrey II-i series Specifications

General IconGeneral
BrandZeiss
ModelHumphrey II-i series
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals