Humphrey Field Analyzer II-
i
series User Manual 2660021145640 A
Kinetic Testing
13-1
(13) Kinetic Testing
Introduction to Kinetic Testing 13-2
Performing Kinetic Perimetry Manually 13-3
Pre-Defined Kinetic Test Patterns 13-13
Running Automated Kinetic Tests 13-14
Social Security Administration Kine
tic Disability T
est 13-24
Special Mapping 13-27
Viewing Kinetic Tests 13-39
Printing Kinetic Tests 13-43
Designing a Custom Kinetic Test Pattern 13-48
Creating the Aphakic SS
A
Disability Test 13-56
In addition to static perimetry, the Humphrey Field Analyzer II M
odel 750
i
(and optional on Model
740
i
and 745
i
) allows you to perform kinetic perimetry. The HFA II-
i
’s Kinetic feature emulates
manual standard Goldmann perimetry. You specify the stimulus size, intensity, speed, and color for
plotting kinetic isopters. You can present stimuli starting from 80 degrees
(peripherally), 30 degrees (centrally), or anywhere you choose (with
Custom Scan). Pre-set testing sequences are available for automatic or
step by step procedures. Scotoma mapping, blind spot mapping and
static point display are available for investigation of small areas of the
visual field. You can choose the location of the starting points with a
glidepad or even by touching the display screen. You also can create
Custom Kinetic test patterns to satisfy specific needs.
The Kinetic software comes factory-installed on all
new HFA II Model
750
i
instruments. For Model 740
i
and 745
i
instruments, you must
activate the Kinetic software for it to function on your HFA II-
i
.
To obtain a Kinetic license, you must contact Carl Zeiss Meditec:
In the U.S.: Call Ca
rl Zeiss Meditec at 1-800-341-6968.
Outside the U.S.: Con
tact your local Carl Zeiss Meditec distributor.
Once you have obtained your license, you c
an activate it using the
procedure that is provided in Appendix (J) beginning with
“Installing Additional Software,” on page J-3.
C
a
r
l
Z
e
i
s
s
M
e
d
i
t
e
c
To Next Page
Loading...
Need help?
General
