To Next Page

To Previous Page

Humphrey Field Analyzer II-

series User Manual 2660021145640 A

General Operation

2-15

Accessing the Vertex Monitor (Model 750

only)

1Start at the System Setup screen. Select the Vertex Monitor

drop-down menu.

2Choose between ON and OFF.

Note: When the Vertex Monitor is turned on, a beep will sound if the patient backs away from the

rial lens during testing. Although the test will not pause, a message will remain on the screen until

cleared by the operator. This feature only works if Gaze Tracking has been initialized successfully and

the trial lens holder is in the Up position. For additional information, see “Vertex Monitor (Model

750i),” on page 5-6.

Setting the Time and Date

1Start at the System Setup screen. Select SET TIME AND DATE.

2Select the Time Format drop-down menu.

Choose 24 HOURS or AM/PM fr

om the drop-down menu.

3Press TIME ENTRY. Input the correct time on the keypad, then press

ENTER.

Note: If you have selected the AM/PM format, you must en

ter either AM or PM with your time entry.

4 Select Date Format. Choose MM-DD-YYYY, DD-MM-YYYY or YYYY-MM-DD from the drop-down

menu.

Note: MM=Month, DD=Day and YYYY=Year.

5 Select DATE ENTRY. Input the correct date from the keypad, then press ENTER.

Zeiss Humphrey II-i series User Manual

Questions and Answers: