Networking Reference
Humphrey Field Analyzer II-
i
series User Manual 2660021145640 A
I-24
Setting Up Save & Transmit for EMR/PMS/DICOM Systems
1 On the System Setup screen select SAVE/TRANSMIT OPTION to display the screen that is shown
in Figure I.28.
2 Open the Transfer Destination drop-down box and select EMR/PMS HOST for EMR/PMS systems
and DICOM systems using DICOM Gateway 1.0 (Figure I.28), or DICOM ARCHIVE for DICOM
systems using DICOM Gateway 2.0 (Figure I.29).
Figure I.28 Setting Transfer Destination Drop-Down Box to EMR/PMS Host
Figure I.29 Setting Transfer Destination Drop-Down Box to DICOM Archive
Note: The ERM/PMS Host option in the Transfer Destination drop-down box is only available in the
listing if you have licensed the HFA-NET Pro networking software on your HFA II-
i
. The DICOM
Archive option in the Transfer Destination drop-down box is only available in the listing if you have
licensed the DICOM Gateway 2.0 software on your HFA II-
i
. Otherwise, these options will not
appear in the Transfer Destination drop-down box. Further information on these options may be
found at the end of this section in Table I.8.
To Next Page
Loading...
